
Builder Last Online: May 2019


Model Scale: 1/8
Rating:
Thanks: 0

Started: 10-18-06
Build Revisions: Never

Here's my entry for the Deuce celebration. Dan and I started working on the protoype for this V-12 Flathead a while back. He mocked up the head and cast a few in
resin
for me to work with. When the engine is complete he will cast it and make it available as a kit.
Photo of the top side of the head...I still need to add a water neck to the front.

Bottom side of the head.

This is a comparision shot...Top is the R/M kit v-8 Flathead.....center is Dan's metal pre-drilled Flathead with acorn nuts.....bottom is the resin
V-12 head.


Photo of the top side of the head...I still need to add a water neck to the front.

Bottom side of the head.

This is a comparision shot...Top is the R/M kit v-8 Flathead.....center is Dan's metal pre-drilled Flathead with acorn nuts.....bottom is the resin


Show Complete First Post
Show Your Support
- This build may not be copied, reproduced or published elsewhere without author's permission.Please note: The first post will be displayed at the top of every page.
Bookmarks