ScaleMotorcars

Welcome to ScaleMotorcars the worlds leading large-scale model building forum.

• 

  
• Please vote for MOTM. Thanks

  Results: MOTM

  100.00%

  Voters: 1. You must be a member to vote in this poll

  
  Please be sure to nominate more builds for next month's M.O.T.M. Thanks!
• New Forum Posts

  • 

    January 13, 2010 The « under wheel covers » were easier to do, even if the thinner material (0.2mm) gave more trouble that the brass used for the...

    The story about my 1:12 Studebaker...

    10-23-19, 05:09 AM
    
  • 

    The wheel hubs were machined inside; to work the outside, I had to make a special tool. The hubs will be attached with the studs to the tool and then...

    1:12 1932 Cadillac V-16 frame and...

    10-23-19, 03:30 AM
    
  • 

    Hello all , I am new here , obviously , and 67 years old. I have built plastic on and off since I was 4 years old. My dad helped (built) a Renewal...

    Introduce Yourself

    10-22-19, 11:10 AM
    
  • 

    Brake Pads, more designing in SolidWorks… Ready to send off to Fraxional for growing.

    Lola T-70 Mk III

    10-21-19, 09:12 PM
    
  • 

    Thanks Roger!

    Jaguar XK Junk Heap

    10-21-19, 07:05 PM
    
  • 

    Thanks Markus! However, as I wrote, it was requiring some work to get usable.

    The story about my 1:12 Studebaker...

    10-21-19, 10:35 AM
    
  • 

    Brilliant pressing tool. Hats off! Markus

    The story about my 1:12 Studebaker...

    10-21-19, 03:15 AM
    
  • 

    More details and the other (outer) side. The rotors will be machined; I just wanted a blank to make sure it would all fit later. Now to make the...

    Lola T-70 Mk III

    10-20-19, 08:51 PM
    
•