PAST MASTERS and...
11-25-21, 03:25 PM
Vintage Fixings
10-28-21, 01:15 AM
Greetings and...
10-22-21, 10:32 PM
This site has become...
12-02-21, 01:27 PM
Cleaned up the site...
09-17-20, 07:36 PM
The rough work is done on the tire pattern. The face towards the rear of the lathe will be refined with an hand held tool. This is the best way to...
That's correct. I could not machine a larger piece of metal! The process is the same as for the other tires; I will publish more pictures.
Roger, I tried to correct the written word "pece" to correct PIECE but the forum software did not accept this. The meaning of my last sentence is...
I too have the same problem. For the moment, this forum is rather unfriendly! Sorry, I don't understand what you are saying at the end of your...
No, Paul. I just remove the unwanted brass from picture in post 740 to get what you see at the picture in post 741. Makes a lot of chips!
30 minutes time of Try & Error to log in the Forum and this thread !!! Since weeks poor horror nice work again Roger I think Your late is with...
Since a few weeks there are VERY MUCH PROBLEMS TO LOG IN of this site. Some days no chance to get in other days I had to spend 15 minutes or longer...
I hate to say anything as I haven't been here long but it is an unbelievably troublesome site technically. I am getting "Max User Connection"...
Downloads
The rough work is done on the tire pattern. The face towards the rear of the lathe will be refined with an hand held tool. This is the best way to...
1:12 1932 Cadillac V-16 frame and...