Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
Buck, that ball would be about 0.3mm in diameter (0.012"). It will be easier to turn it on the lathe... It seems that my expectation about a...
Simple and very effective modeling. In your computer, where you process the photographs you upload. See if you can "flip" an image? I've done...
If those grease fittings could be drilled to accept the very tip of a ball point pen, it might look ok.
Model making is a very good way of examining the mechanical and engineering developments of the 20 century. Cars especially. Much was adapted from...
Greetings and thanks for putting up with my relatively crude construction! I went to work on making a driver for this. The challenges in this is...
Thanks for the comments. Probably a pin will be enough. I will have to try. Those grease fittings were the standard at that time...Nothing specific...
No I didn't, In 1/4th scale, I could use very small Ball Detents, -think of a set screw with a captured sprung ball at one end. But in your...
You are welcome! The angle may be altered a bit, it's just a matter to adjust the pawl accordingly. You did not comment about the grease...
Downloads
Buck, that ball would be about 0.3mm in diameter (0.012"). It will be easier to turn it on the lathe... It seems that my expectation about a...
1:12 1932 Cadillac V-16 frame and...