Builder Last Online: Sep 2016
Model Scale: 1/8 Rating: (3 votes - 5.00 average) Thanks: 0
Started: 10-07-11 Build Revisions: Never
I have all the reference materials including the real car in my garage to build this. This will be a follow on tutorial to the Model T build with a more complicated subject that will take a great deal more time to build. A this point I am not really sure where I will end up but hope to learn more about building cars instead of planes and have a little fun doing it.
Here is the start of the engine by locating the cylinders. I usually start my builds with the engine which is generally the most difficult and time consuming part of the build. Here I have marked, center punch and starting with a smaller drill bit; drilling the holes. Initially the two sheets were spray glued together to locate the holes, then separated for subsequent drilling.
I drilled holes progressively larger to one size below the finished size. This was done for both parts of the top and bottom of the block, which are the scribe lines on the sheets.
I then used a larger ream to very carefully sneak up on a press fit for each cylinder tube. The press fit is critical for holding the parts in space while being soldered. This start will be the foundation of the engine assembly.
Here the first sheet has been reamed with cylinder walls press fit in place. The engine drawing at 1/8th scale is in the background.
Here the second sheet has been clamped to the first to be matched. In using a drill press drift and out of round will occur, the ream gets the holes back to round for a press fit. The second sheet once clamped in place need trimming to match and this was accomplished very carefully using a sharp X-acto blade and the first sheet as the pattern to match to. The blade will carve away the brass and work slowly to not only achieve the match but also the press fit.
Show Complete First Post
Show Your Support
- This build may not be copied, reproduced or published elsewhere without author's permission.Please note: The first post will be displayed at the top of every page.