Close

Results 1 to 1 of 1
    1. Kit: , by (VIP/Sponsor) gbritnell is offline
      Builder Last Online: Jan 2019 Show Printable Version Email this Page
      Model Scale: 1/8 Rating:  Thanks: 0
      Started: 07-01-13 Build Revisions: Never  
      Not Supported

      Gentlemen,
      I have to apologize for the text in this posting. Had I just looked a little down the list I would have seen that I in fact did post the entire build. Duh! I had purchased an 11 inch 3 bladed composite prop to get the engine running but the problem with this and most small engines is the lack of flywheel affect when scaling them down. I then mounted a bronze flywheel to see if I could get the idle down and make the necessary carb adjustments, which I did. With that success I then set out to make the aluminum prop that you see in the video. The blades were machined with an airfoil shape but were left heavier to provide the needed mass without having to resort to mounting a huge prop. This one is 13 inches in diameter. I have since uncovered other issues with it running and am making the necessary changes as I go.
      http://youtu.be/V8SDqPE4kZA
      gbritnell
      Show Complete First Post

      Show Your Support

      • This build may not be copied, reproduced or published elsewhere without author's permission.
        Please note: The first post will be displayed at the top of every page.
    JOIN THE SMC ALLIANCE NOW

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Quick Scale Calculator

 
Scale Calculator   Scale Factor   Real Size:     + Deluxe Scale Calculator
  1: th   Which equals Convert measurement: Reset or clear:  
  Any Scale   Scale Size:     + Deluxe Metric Calculator
 
Top