Close

Results 1 to 1 of 1

Thread: Rotarty Table

    1. Kit: , by (Member) fadt is offline
      Builder Last Online: Nov 2016 Show Printable Version Email this Page
      Model Scale: 1/8 Rating:  Thanks: 0
      Started: 10-17-16 Build Revisions: Never  
      Supported Scratch Built

      I use the small emco lathe and mill for my machining. I wanted to make an 1/8th scale spoked front wheel for my T Bucket, so set about making a table for it.



      Started with an approx size I was aiming for and searched out a 90 tooth gear and worm that suited the size I wanted. This would give me a 1* movement for a 1/4 turn of the handle. Should be good enough for what I wanted to do. Next step was to turn out a recess in some mild steel for the gear to sit in and push a centre hole though the block.

      I am sorry but I dont have pics of making this little table as it was quite a long time ago when these were not readily available for the modelling world. Before the days of digital cameras and ease of putting pictures on the web.
      Show Complete First Post

      Show Your Support

      • This build may not be copied, reproduced or published elsewhere without author's permission.
        Please note: The first post will be displayed at the top of every page.
    JOIN THE SMC ALLIANCE NOW

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Quick Scale Calculator

 
Scale Calculator   Scale Factor   Real Size:     + Deluxe Scale Calculator
  1: th   Which equals Convert measurement: Reset or clear:  
  Any Scale   Scale Size:     + Deluxe Metric Calculator
 
Top