So much time for so little! In fact, I spent 3 afternoons to install the front seat into my '72 coupe, scale 1:1. Even if it was only 5°C, I did not...
If the provision for the clutch lever went not too bad (I have much more time to design and "place" it on the transmission than to do the part), it's...
The main case was silver soldered to the flywheel cover. This operation was critical as the transmission must be in a good alignment with the engine....
The last details were added on the main body of the transmission. On the LH side: drain and refill plugs. On the RH side: 3 attaching points and the...
The last few days saw some improvements at the parts from the transmission. Elements were added at the main body; some more will come next. At first,...
The hole was drilled first. Then hammering on a body doll. I could not get the depth I wanted, therefore I cut a slice and silver soldered. Maybe is...
The pictured parts will be the transmission. The "thing" at left is the main case and the other one at right should be the junction between the case...
Name: Medal of Outstanding Accomplishment
This medal is of the highest honor that can be awarded to a member. These are members who have shown excellence in everything they contribute to Scalemotorcars.com
Connect With Us