Results 1 to 1 of 1
    1. Kit: , by (Super Moderator) Mario Lucchini is offline
      Builder Last Online: Jun 2011 Show Printable Version Email this Page
      Model Scale: 1/8 Rating:  Thanks: 0
      Started: 01-06-07 Build Revisions: Never  
      Not Supported

      Take assorted Allen hex screws , try them against your favorite scale bolts & nuts, turn them in the lathe to be as slim as possible & screw them in a hex bass bar.
      You can do this also in a Dremel Mini Nut & Bolt drivers & use files.
      The open wrench shown, was made turning a ball in the tip of a turned down brass bar, & then milling flats on the ball at opposite sides, then the A/F dimension was milled in the tip.
      Again for those of you without a lathe, you can do it with a Dremel Mini Nut & Bolt drivers or hand drill, and use assorted files for the task.
      I finally punched the dimensions on the handles for time & curse saving reasons...
      If you do this slowly in a period of time, you will end with an impressive amount of drivers, proudly saying "I made these", and for very little money.







      Show Complete First Post

      Show Your Support

      • This build may not be copied, reproduced or published elsewhere without author's permission.
        Please note: The first post will be displayed at the top of every page.

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Quick Scale Calculator

Scale Calculator   Scale Factor   Real Size:     + Deluxe Scale Calculator
  1: th   Which equals Convert measurement: Reset or clear:  
  Any Scale   Scale Size:     + Deluxe Metric Calculator