Close

  • Need Help with Photo etch

    Results 1 to 3 of 3
      1. Kit: , by
        onlyslimit
        (Member) onlyslimit is offline
        Builder Last Online: Jan 2013 Show Printable Version Email this Page
        Model Scale: 1/8 Rating:  Thanks: 0
        Started: 01-13-13 Build Revisions: Never  
        Not Supported

        Hello fellow members of this forum,
        I'm new to this forum and I'm Sky~
        I am completely confused to where I should be posting this, so sorry if I have posted it in the wrong sections, please replace it to another category if I am wrong. sorry >.<.This is actually my first time dealing with photo etch, but I full know how to remove, attach, etc. But this has gotten me stuck and the instructions aren't very clear at all.
        Need Help with Photo etch-img_1218-jpgNeed Help with Photo etch-img_1210-jpgNeed Help with Photo etch-img_1212-jpgNeed Help with Photo etch-img_1214-jpgNeed Help with Photo etch-img_1219-jpgNeed Help with Photo etch-img_1221-jpg
        As you can see in the second picture that's a sign with a hobby knife Need Help with Photo etch meaning remove... and then in the third picture there are red lines around the break disc with that sign... so do I remove that part or just glue to photo etch on top? If you look at my actual piece there are detail sticking out and that would require me to sand Need Help with Photo etch it down.... so do I remove it or not?
        Thanks for any help in advance~
        Sky
        Show Complete First Post

        Show Your Support

        • This build may not be copied, reproduced or published elsewhere without author's permission.
          Please note: The first post will be displayed at the top of every page.

    1. onlyslimit
      onlyslimit is offline Australia
      onlyslimit's Avatar Member
      Name
      Sky
      Join Date
      Jan 2013
      Posts
      2
      This kit is from Fujimi Need Help with Photo etch , kit: Eva TrackStar Kawasaki ZX-10R


      Need Help with Photo etch
      01-13-13, 11:17 PM QUOTE QUOTE #2
    2. Zonic2001
      Zonic2001 is offline United States
      Zonic2001's Avatar Member
      Name
      Luis
      Join Date
      Oct 2013
      Posts
      3
      I built about 5 MotoGP motos and a couple of choppers. The PE part most likely will be the sole disc. You need to cut the center of the plastic (model kit part) brake disk (where the rod will go through) and add it to the PE for a complete part. Why? If you add the PE to the plastic part it will be too think to put the brake caliper over it. Got it?
      12-12-13, 02:43 PM QUOTE QUOTE #3
    « Bugatti type 59(Steam version) | Does anyone knows how to do simulate "fiberglass" texture? »

    Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •  

    Forum Rules

    Quick Scale Calculator

     
    Scale Calculator   Scale Factor   Real Size:     + Deluxe Scale Calculator
      1: th   Which equals Convert measurement: Reset or clear:  
      Any Scale   Scale Size:     + Deluxe Metric Calculator
     
    Top