ScaleMotorcars

Welcome to ScaleMotorcars the worlds leading large-scale model building forum.

• 

  
• Please vote for MOTM. Thanks

  Results: MOTM

  100.00%

  Voters: 1. You must be a member to vote in this poll

  
  Please be sure to nominate more builds for next month's M.O.T.M. Thanks!
• New Forum Posts

  • 

    Simple and very effective modeling. In your computer, where you process the photographs you upload. See if you can "flip" an image? I've done...

    Ferrari 512 S Analog

    04-11-21, 03:05 AM
    
  • 

    If those grease fittings could be drilled to accept the very tip of a ball point pen, it might look ok.

    1:12 1932 Cadillac V-16 frame and...

    04-10-21, 02:41 PM
    
  • 

    Model making is a very good way of examining the mechanical and engineering developments of the 20 century. Cars especially. Much was adapted from...

    1:12 1932 Cadillac V-16 frame and...

    04-10-21, 02:11 PM
    
  • 

    Greetings and thanks for putting up with my relatively crude construction! I went to work on making a driver for this. The challenges in this is...

    Ferrari 512 S Analog

    04-10-21, 12:39 PM
    
  • 

    Thanks for the comments. Probably a pin will be enough. I will have to try. Those grease fittings were the standard at that time...Nothing specific...

    1:12 1932 Cadillac V-16 frame and...

    04-10-21, 02:49 AM
    
  • 

    No I didn't, In 1/4th scale, I could use very small Ball Detents, -think of a set screw with a captured sprung ball at one end. But in your...

    1:12 1932 Cadillac V-16 frame and...

    04-09-21, 02:27 PM
    
  • 

    You are welcome! The angle may be altered a bit, it's just a matter to adjust the pawl accordingly. You did not comment about the grease...

    1:12 1932 Cadillac V-16 frame and...

    04-09-21, 12:29 PM
    
  • 

    Excellent solution on the ratchet teeth! Several of us can use that idea! Thank you Roger!

    1:12 1932 Cadillac V-16 frame and...

    04-09-21, 11:14 AM
    
•